Geotechnical Engineering Jobs

I need a detailed geo technical report based on video documentation of the geo cell erosion system that was installed on my shared common driveway was unnecessary. The driveway shows no signs of failure, so the system was not required. I work in the construction industry has a PM for a civil contractor. Send me an e-mail address so I can provide a link for the video files. Requirements: - Analyze MP4 videos - Focus on soil stability and water drainage - Provide a comprehensive report Ideal Skills & Experience: - Experience in video analysis - Knowledge of erosion systems and landscaping - Strong report writing skills

I have a project underway in Americus, Georgia that requires a formal Standard Proctor compaction test on the clay soils within the foundation footprint. The excavation will be open and accessible, so you can collect representative samples on-site without delays. Your scope is straightforward: perform the field sampling, run the laboratory Standard Proctor, and deliver a stamped report summarizing optimum moisture content, maximum dry density, and any recommendations if the results fall short of specification. Please include photographs of sampling locations and note test procedures followed (ASTM D698). Timing is important—we are targeting next week, but I can coordinate around your lab schedule if needed. Bring any necessary field tools; site access and safety briefing will be ...

I need a full engineering design for a bored cast-in-situ pile, 600 mm in diameter and 21 m deep, capable of carrying 175 tonnes. The piles will support a multi-storey commercial building to be erected on sandy soil, so the design must reflect both the reduced shaft friction typical of this stratum and the higher potential for scour near the surface. Please include all geotechnical and structural calculations, load-settlement analysis, reinforcement detailing, and a clear layout plan showing pile spacing, cut-off levels, and cap geometry. I also expect a concise design report referencing the governing code you choose (IS 2911, ), together with editable drawings in DWG or REVIT and a sealed PDF set ready for permitting. Deliverables: • Design brief with assumptions and safety factors...