I am looking for a programmer to code my PIC microcontroller to drive a 6v dc motor using a PWM technique -
The battery is in series - 3.6v x 2 = 7.4V LiPo 1000mAh
Nominal voltage: 6VDC
No-load speed: 13000rpm
No-load current: 0.46A
Stall torque: [url removed, login to view]
Stall current: 11.8A
The PWM technique should maintain the voltage at an average of 6V to the motor until the voltage of the battery drops below a threshold value, this will ensure that the motor speed does not drop as the battery discharges on use.
You can find attached the design layout of the PCB and microcontroller/driver used.
Having experience in pic from last 5 years, we have good knowledge regarding pcb design, circuit development & firmware. I already worked on similar projects, so I can execute this project within time