Embedded C Developer Needed

Dear Client I am excited to offer my skills and experience in Embedded C/C++ programming for your project. With knowledge in HMI-based GUI development and hands-on experience in various microcontrollers such as AVR/PIC/ARM/STM32F4/Xilinx XC7Z020, I am confident in my ability to deliver quality work. I have extensive experience in working with peripherals such as UART/SPI/I2C/ADC/PWM and FPGA interfacing, including C code development for ADC IC, DAC IC, parallel data interfaces, PWM channels, SDRAM, SD card, USB, RS232, and current steering DAC. Additionally, I am skilled in preparing and implementing pre-production plans, including bill of material preparation, assembly instructions, and final quality testing procedures. My proposed budget for this project is reasonable and competitive, and I am committed to delivering high-quality work within the given timeframe. Thank you for considering my proposal, and I look forward to the opportunity to work with you. Best regards, Abbas JawadWala SMB ElectroTech

Are you looking for freelancer or permanent employee? I have subset of the skills you have listed out. Please contact.

Hello I am embedded software engineer I know C/C++ programs very well and i used on embedded side to develop devices So i can help you

Im, not a robot) We are an RnD company in Belgium with experience in electronic design (schematic, PCB design) and firmware design. We are experienced in MCU/SoC firmware design using Linux/Android/FreeRTOS/SafeRTOS/eCOS/QNX and more. We have 10+ years of working with different technologies. Our company is one of the best in the EU as a service provider because we have experience, a good team, and a lot of success projects done in the past. Let's discuss your project - I can share my experience.

Hi, I have read your job post and I am a Professional C/C++ developer with 5 years of experience in industry. I can do your perfectly. Please reach out with more details in chat. Looking forward.

I have five years of experience in embedded development and am very familiar with graphical interface development

Please discuss

Have more than 10 years of Experience in Electronics Product Development, Developed High-Quality Electronics Products. Developed below Products: 1. FPGA & Verilog Code based Boards: Video Processing Board Signal Processing board 2. Embedded systems using Microcontroller/Microprocessor with Embedded C: Elevator Controller Motor Driver DC to DC Converter AC to DC Converter Battery Management System 3. IoT Based unit: Air Quality Monitor Wind Spectrometer 4. RF Units Up/Down Converter Lumped FIlter Handled below Devices: FPGA: AMD XIlinx Zynq Ultrascale+ MPSoC, Kintex-7, Intel Stratix 10 SoC FPGA, Intel Arria 10 SoC FPGA & Microchip Smartfusion FPGA Microcontroller/Microprocessor: PIC, TMS320, RM57, MSP430, iMX6, iMX8 & Intel i7 IoT: ESP32 & nRF

I am a Electronic Component supplier , I can supply you with Integrated Circuits, Microchips , MicroControllers, Voltage Regulators, Relays, Crystals, Mosfet, ASIC , FPGA, Transistors and other (LCD, Connectors, Heat Sink etc. ) Active and Passive Components. Components can be delivered any place in India.

Hello , I m embedded software enginner on Automotive Indestury. Im working a lot of microcontroller family like STM32, PIC12/16, NXP S32K, INFINEON AURIX , ARDUINO, ESP32. I can help you for projects