The design will be used to create a prototype
finished and assembled prototype also needed
The person using this product would squeeze at 1A-1B or 5A-5B causing 2-2A or 3-3A to widen. Mechanism is similar to that of a classic clothes pin with position 1 & 5 containing a spring to allow that operation.
2 & 2A should end with a very small spool that will allow a thread (#6) to travel freely. 3 & 3A should end in a cup shape that will hold the thread (#6) in place. A sample photo of thread with small balls attached at one end is included.
#4 must have a spring mechanism in the center to maintain tension thread (#6) between the two ends (#1 & #5). #4 can be attached to #1 & #5 running through the springs of each.
Arms (#7) should open to approximately 4 inches at widest point.
Total length of product should be 9 inches or less.
45 freelancers are bidding on average $152 for this job
hello sir I am professional 3d modeller with first class in engineering .i am capable in 2d drawing , 3d modelling , animation , motion etc . please give me an opportunity to work. regards kalp
Hello I'm Navdeep. I have done a lot of similar work and deem myself able to complete your work with best quality. To see my sample work, please send me a message. Thanks