PROFESSIONAL PLASTIC MOULD DESIGNER

Status: Closed
Prize: $70
Entries Received: 3
Winner: shsew87

Winner

Contest Brief

PLEASE Check the document carefully for better udnerstanding of the design and what need to be done.

* Do not change the original shape or size of the product.
*Changes only will be work with the lid and body part

Winner should send all the files for moulds.

Send your desing in the easiest format to understand the design.

Recommended Skills

Winner

Post a Contest Like This

Employer Feedback

“talented designer. ”

Kiyashrahman, Bangladesh.

Top entries from this contest

enghamza12 Palestinian Territory

0

Public Clarification Board

Moldingmaker
- 4 years ago
HOW CAN I SEND THE NEW DESIGN TO YOU
- 4 years ago
1. Moldingmaker
  - 4 years ago
  Heyyy
  - 4 years ago
shsew87
- 4 years ago
Hello,It is little bit confusing whether you want only the product drawing for the molds or Mold drawings for the mold fabrication.Could you please clarify. tks.
- 4 years ago
1. Contest Holder
  - 4 years ago
  Only product drawing is required. The design should be practical to put on injection mold.
  - 4 years ago
MECHANICDESIGNER
- 4 years ago
Do you have the both model files in solidworks .sldpart file format ?
- 4 years ago
1. Contest Holder
  - 4 years ago
  Please check, I have added the obj. file
  - 4 years ago
spandya1
- 4 years ago
Do you have the both model files in solidworks .sldpart file format ?
- 4 years ago
1. Contest Holder
  - 4 years ago
  I don't have them but I make send it for you.
  - 4 years ago
2. Contest Holder
  - 4 years ago
  please check , I have added the required file
  - 4 years ago
Moldingmaker
- 4 years ago
Hello, I have reviewed the product. I have a few questions. 1- Can you give the mold exit angle for the product? 2- Mold design should be made as plastic injection. 3- Did you give plastic shrinkage for the product raw material. If you did not give the raw material, I will apply shrinkage. 4- How many eyes can you stay? 5- Whether you want hot runner or cold runner mold.
- 4 years ago
1. Contest Holder
  - 4 years ago
  1. depends on the design, 2 .yes plastic injection molding machine, 3. hthe raw material is PP. 4. ? 5. cold runner.
  - 4 years ago
2. Contest Holder
  - 4 years ago
  the mold design is not necessary but the actual product design is necessary.
  - 4 years ago
ceanet
- 4 years ago
Do you want to reuse the cap after breaking the seal?
- 4 years ago
1. Contest Holder
  - 4 years ago
  Yes, the cap will be reused afterwards.
  - 4 years ago
dedierwanto2686
- 4 years ago
#guaranteed
- 4 years ago
1. Contest Holder
  - 4 years ago
  100%
  - 4 years ago
Kanti95
- 4 years ago
The lock is done outer part of lid or inner part of the lid?
- 4 years ago
1. Contest Holder
  - 4 years ago
  d) Depends on your design mostly.
  - 4 years ago