Require detail schematic safety relay (logic)circuit which Operates on Estop functionality
$10-30 USD
Paid on delivery
The project should provide the detail schematic of safety relay logic which Operates on Estop functionality/SMK sensor. The ckt should work as follows:
1. When any of the sensor is active (Estop1 & Estop 2) & SMK sensor. The sensor sends the signal to safety relay.
2. The safety relay deenergize contactors & disconnects the 3phase 400VAC/20 feed from facilities outlet to power distribution box.
3. When the 3phase power(400VAC/20A) is disconnected from power distribution, the power distribution box is turn off(does not get 3phase - 400VAC/20A supply).
4. When the operator presses the Power reset switch, then Ckt should reset safety relay. The safety relay will energize the contactors & 3phase (400VAC/20A) is feed to power distribution box. The Power distribution box gets (turns ON) 3phase power (400VAC/20A).
5. Please refer the attach schematic which was design for single phase (230VAC). I need similar schematic in terms of detailness & logic (relay & contactors, no transistor microcontroller ckt )
Project ID: #30438430
About the project
6 freelancers are bidding on average $56 for this job
I have done Electronic and Communication and was a Non Degree Program student at IIT Gandhinagar with 90%. I have lot of projects, filed research papers, won startup contests using Micro-controller, IOT, Nanotechnology More
Hello, Thanks for posting the project again. As I have suggested you earlier, you can by pass the relay also and achieve these functional requirements. With Best Regards, - Debasis Basu
I am interested to do the logic and circuit as per your requirement .......,..............................................................................
