Embedded Software (with BLE experience with Nordic MCUs )

£18-36 GBP / hour

Closed

Posted

over 2 years ago

£18-36 GBP / hour

The experienced Embedded Engineer is required to assist with the development of a portion of the product for the automotive industry. Details will be shared over the zoom call. The project may take time from a few weeks to a few months. Also, if collaboration if successful, more work can be provided. Experience required: Bluetooth Low Energy. BLE = 5.0 (5.1 ideally). Experience with Nordic MCUs (critical), ideally with nrf528323 and nrf52840. Experience with BLE devices on Central and Peripheral configuration. Feel free to reach out to ask questions.

Bluetooth Low Energy (BLE)

Project ID: 32727688

About the project

5 proposals

Remote project

Active 2 yrs ago

Looking to make some money?

Email address

Benefits of bidding on Freelancer

Set your budget and timeframe

Get paid for your work

Outline your proposal

It's free to sign up and bid on jobs

5 freelancers are bidding on average £33 GBP/hour for this job

@iamanujpathak

Hello Sir, I have 6+ years of Embedded and IoT system development experience. I have extensive nordic mcu experience. I have started with nRF51822 and extensively using nRF52832 and nRF52840 in now a days products. I am working with Nordic SDK since version 12 was launched for nRF51. latest i have used is SDK17. I have even done a project for PSLocks using segger embedded studio and NCS. I do have some basic experience with Zephyr too. In a Data Aquition project for DataCredibility i have used simultaneous central and peripheral mode to collect data from sensors (as Central ) and pushing to gateway (as peripheral ). the same project also uses LE Coded Phy and AE for long range and more data. Feel free to ask me anything related to nRF MCUs Regards

£25 GBP in 40 days

5.0

(11 reviews)

5.5

@zhuhaiclicky

Hello I am an IoT developer and I have developed the nRF52840 and nRF52832 firmware and hardware. I have experience in developing the peripheral, central and mesh device using NRF-SDK and Zephyr. And I can design the PCB and manufacture the prototype, mass product. Currently I have the development board and modules so I can start working immediately. Please contact me, I hope we can discuss more details via a private chat. I am looking forward to your response. Thank you.

£30 GBP in 40 days

5.0

(1 review)

3.7

@jitendrabaraiya

I have more than 9 years experience on embedded hardware design and firmware development .and I have already worked on NRF52832 and NRF52840 with nordic semiconductor with Zephyr SDK of nordic . and also NRF52832 with arduino . So i can do your job within a time limit with your satisfaction.

£35 GBP in 40 days